This Episodes Questions:
Another dedicated aussie listener, hey guys, thanks for a great podcast. My question is, I recently purchased a K1 Max, not many issues except hot end blockages 3 in as many weeks, it’s even causing under extrusion and have to disassemble the hot end to clear it out, thing is it seems to line the inside just above the nozzle which seems impossible to clear, any advice would be much appreciated, is it me the way I’m changing filament or is it an issue with the printer? Thanks in advance Roy
My question is about the new K1 firmware hack provided by crealitys outlet on giithub, is it worth the risk? I’ve been doing the yards in checking and researching, but cannot other than maybe a couple of issues from people on Reddit I have around 3 years experience in 3d printing so have some knowledge thanks avid listne4 to your 0odcast, great listening Roy
Hi.
I have an Ender 3 V2 Neo, and the bed is in very bad condition and the prints are not sticking well, while i wait for a new bed i want to ask, can i use lacquer on my bed (I don’t know which type is it)?
Thanks, Noa